Milliteslas to Milligauss
Snapshot
1 Millitesla equals 10,000 Milligauss. Conversion Encyclopedia uses the same fixed conversion basis across the calculator, common values, and reverse page for this page.
- Reference basis: This conversion uses exact tesla-based magnetic flux density definitions.
- Example: For 0.001 Milliteslas, the result equals 10 Milligauss.
- Use the reverse page if you need the opposite direction with the same basis.
Use the interactive calculator below for custom values and the common-value table for quick checks.
Converter Calculator
10,000 Milligauss (mG)
SwitchExplanation
Formula: Milligauss = Milliteslas × 10,000. Why: this is a cross-system magnetic-flux-density conversion. The calculator normalizes the value through teslas, then applies the exact gauss relationship for consistent SI and CGS results.
Milliteslas (mT): a magnetic-flux-density unit equal to one thousandth of a tesla, common in magnets, sensors, and laboratory field measurements.
Milligauss (mG): a small gauss-based unit often used for low-field and environmental magnetic field readings.
This route is useful when translating magnetic flux density values across SI and CGS conventions so sensor output, geomagnetic readings, and technical references stay comparable.
This conversion is purely multiplicative because both units reduce through teslas using fixed SI and CGS magnetic-field definitions with no offset.
Common Conversion Values
| Milliteslas (mT) | Milligauss (mG) |
|---|---|
| 0.001 | 10 |
| 0.01 | 100 |
| 0.1 | 1,000 |
| 1 | 10,000 |
| 10 | 100,000 |
| 100 | 1,000,000 |
| 1,000 | 10,000,000 |
Frequently Asked Questions
How does this converter compute Milliteslas to Milligauss?
The factor is derived from exact tesla normalization using fixed SI and CGS relationships.
How can I convert back from Milligauss to Milliteslas?
Use the mirror Milligauss to Milliteslas route; it applies the inverse relationship for the opposite direction with the same assumptions.
Are fractional milliteslas inputs valid in Milliteslas to Milligauss?
Yes. Decimal inputs are supported for Milliteslas to Milligauss, and the mirror direction keeps inverse assumptions aligned.